CPCPGS3061 - Install and commission Type A gas appliances

Unit code: CPCPGS3061 | Study level: TAFE
Nominal hours:
30
Location
Sunshine
Prerequisites
CPCPCM2043 - Carry out WHS requirements; and
CPCPGS3054 - Calculate and install natural ventilation for Type A gas appliances
(Or equivalent to be determined by unit coordinator)
Overview
Enquire

Overview

This unit specifies the skills and knowledge required to install and commission certified Type A gas appliances.

Assessment

For Melbourne campuses

Assessment tasks will be designed to reinforce & extend knowledge and skill competence within set & controlled parameters in accordance with each unit’s learning outcomes & performance criteria requirements, incl the setting of work based practical application tasks designed to provide evidence of competence outcomes, within periodic and scheduled timelines.
Students will be expected to demonstrate the following required skills:

  • installing and commissioning three certified Type A gas appliances:
  • one must be a fan assisted flued appliance
  • one must be installed in a domestic setting
  • one must be installed in a commercial setting
  • calculating natural ventilation for at least one Type A gas appliance
  • conducting a carbon monoxide test.

Students will also be expected to demonstrate the following knowledge:

  • types of approved flues for Type A appliances, including:
  • balanced
  • individual appliance
  • multiple flues
  • natural draft
  • twin wall flues
  • fan assisted flues
  • power flues
  • other approved flues
  • working drawings conventions, symbols and abbreviations
  • results of carbon monoxide poisoning and how it can occur
  • reasons for testing for carbon monoxide
  • consequences of carbon monoxide poisoning:
  • ill health
  • death
  • processes, procedures and techniques for:
  • installing and commissioning Type A appliances and ventilation
  • using carbon monoxide testing equipment to check appliance for spillage
  • existing consumer piping is checked to ensure its compliance with relevant Australian standards and that its capacity is adequate for the additional load
  • size of branch line is calculated according to regulating authorities' requirements
  • properties of gas, gas safety, combustion principles, pressure and flow rates.
  • how to access relevant information, including codes and standards
  • tools, materials and equipment used for the installation and commissioning of Type A gas appliances
  • work health and safety (WHS) requirements for the installation and commissioning of Type A gas appliances.

Required reading

The qualified trainer and assessor will provide teaching and learning materials as required in the form of workbooks produced by Victoria University and/or via the Victoria University e-learning system.

As part of a course

This unit is studied as part of the following course(s):

Certificate III in Plumbing
CPC32420 | Certificate iii | Duration:

Refer to the course page for information on how to apply for the course. VU takes care to ensure the accuracy of this unit information, but reserves the right to change or withdraw courses offered at any time. Please check that unit information is current with the Student Contact Centre.

Search for units, majors & minors